New Drainage lines in Aspley

Plumbaround Pty Ltd has started some rectification plumbing works on a commercial property in Aspley.  The rectification works are to the drainage below the building.  Whilst the property underwent previous renovations a short while ago, the drainage lines seem to have been forgotten and not completed to the Australian Plumbing and Drainage Standards AS3500.img_7669

As you can see by the photos, there a few existing waste lines running from the commercial kitchen and are not to the Plumbing and Drainage Standard and are clearly bowing from the excessive heat running through them.

We intend to supply and install Geberit High Density Polyethylene (HDPE) which is manufactured for the purpose of discharging wastewater from greasy wastes (restaurants etc), trade waste (factories), laboratory waste, sanitary and stormwater.

Geberit HDPE is temperature resistant and can be used in drainage systems for discharge temperatures up to 80° C  and therefore suiting the purpose of this commercial property.img_7662

The job is now set to commence after a slight delay in which we consulted with a Brisbane City Council Plumbing Inspector on most efficient way to achieve the best possible outcome for this commercial premises.  Can not believe it previously passed on a plumbing inspection!

Geberit HDPE pipes and fittings are UV stabilised, and are low on maintenance.  The HDPE pipe gives out a low heat loss through the pipe wall which prevents grease and fat from solidifying on its way out to the grease trap.

Geberit HDPE has a higher abrasion resistance than metal which gives it the edge over other materials in drainage applications where abrasion effects the life of the pipework and it is extremely resistant to chemicals and solvents. Itis the ideal material for use in Trade Waste, Greasy Waste, DWV, Stormwater, Laboratory or Industrial Drainage applications.

We will post some photos once the job is completed, it will look totally different!!

Contact Plumbaround Pty Ltd for more information on plumbing and drainage.  We are happy to visit site and provide you with a QUOTE today.

book-emailbook-phone

Burst water in Albion

On site in Albion this week completing an RPZ repair and whilst replacing the ball valves, our Backflow Prevention Specialist /Plumber has found that the galvanised pipework on this line is in desperate need of repair.  This pipe lead underground and at this stage we can’t tell how far the damage is.   Plumbaround Pty Ltd will return early next week to replace the pipework for the owners of the complex.

Burst Galvanised Pipes

Galvanised pipes were most commonly used in Australian homes built prior to the 1950-60’s. They are not commonly installed in homes today – due to the introduction of copper piping and the cost of producing galvanised pipes, they have been phased out in regards to new installations. Galvanised pipes are iron pipes coated with zinc – this is to prevent corrosion. Galvanised pipes were the most durable pipe available before copper was introduced – but it has been noted that over time the zinc coating actually deteriorates causing the pipe to corrode from the inside and eventually causing it to leak and then burst.

galvpipe

The inside of the pipes can corrode and become plugged with lime, calcium, rust and other debris.
Worse still, is that they can start to leak at any time undetected inside a wall or cupboard which leads to costly damage and the spread of mold.
Many insurance companies will not give coverage to houses with these pipes and fittings or may charge you with a premium.

 Sooner or later a leak will develop so the best thing to do is replacement with copper or PEX plastic pipe.  Exposed pipes are of course much easier to quote on and replace but riser pipes inside walls, under floors and buried  in the ground can be a little more difficult to quote on repair.  The repair however can be done very efficiently and replaced with minimal disruption.
We have experienced plumbers that have completely re-piped/ re-watered many properties.

If your galvanised pipes begin to rust or corrode you may notice that your water becomes discoloured, usually a brownish colour and may contain visible particles. This discolouration is most noticeable first thing in the morning, or if your home has been unoccupied for a period of time. The water should run clear after running your taps for a few minutes – if you notice a reduction in water pressure along with this discolouration, this is usually a sign that your pipes need to be replaced.
We are happy to attend site an provide you with a quote for a property re-water.  Contact us today.book-phone
book-email